HIGHTAGE ELECTRIC

The exact knowledge of the phase assignment in the area of power distribution is an essential requirement for the safe and reliable power network operation. This covers all voltage levels from a low voltage distribution to high voltage transmission systems.

The AC Voltage Test Set T 22/1 is a portable test set consisting of two separate units : the control unit and the high-voltage unit. This division enables the operator to use the test set on site without transport aids. The test set can be equipped.

The Ferrolux location system is the solution for your day-to-day tasks. You can use the system to quickly and easily find cable faults. You can locate lines just as quickly, measure how deep they are and save data including GPS co-ordinates in the memory.

The Surgeflex 8 is a mobile, small and economical fault locating system, specially suited for the fault location in low voltage but also in medium voltage systems, for lighting system, pilot cables and for deep well pump cables.

The PQA 1000 is a high-performance, portable power analyzer, power meter and transient recorder in one single instrument. The PQA 1000 has been developed for mobile operation and is intended for measurements.

With the Centrix SebaKMT diagnosis, in combination with the Centrix fault location system to a fully integrated solution for all additional applications in the field of cable testing, diagnosis. As a basis for the Centrix system used in single or three-phase version.

The VLF sine wave 45 kV with integrated tanDelta is a compact, robust, and portable high-performance test and diagnostic system for medium voltage cables. The 45 kV tester is a multifunctional tool : apart from VLF and DC testing.

The Valve Rod Location Finder FM 880-B is used for easily and reliably locating slide valves, valve rods and well linings and any other objects made of iron or steel as well as magnetic markers. Only ferromagnetic objects can be located.

The Megger TTR25 is an automatic hand-held battery operated transformer turns ratio test set. It effectively eliminates the user from having to kneel or bend down to operate the instrument and speeds up testing time.

The SMRT410 has the “smart” combination of high compliance voltage and high current output to test all electromechanical, solid-state and microprocessor-based overcurrent relays including, voltage controlled, voltage restraint.

The new range of insulation resistance testers (IRTs) are smaller and lighter than previous models yet offer advanced features and rapid charge capability. The range consists of four models an entry level 5 kV and three fully featured units.

Megger DLRO200 measures resistances between 0.1 μΩ and 1 Ω, at high currents. A large liquid crystal display provides all the information needed to perform a test; all test parameters and measurement results are displayed.

SEBA

DISCOM